Installation of plastic composite pipe

Plastic composite pipe is based on the seamless steel pipe and welded steel pipe, inner wall painting with high adhesion, corrosion, hygienic food grade polyethylene powder coating or epoxy painting. After the process of pre-treatment, preheating, inside painting, leveling, and reprocessing, the water galvanizing inner plastic composite pipe is an upgraded product of traditional galvanized steel pipe process, and plastic composite pipe is generally connected with thread.

For the plastic composite pipe during installation, remember not to be buried in concrete. Designer at design time if needed go through the roof and the floor to design a reserve hole, which will be very convenient for future construction . Pipe assembly is certainly received from large diameter to small diameter, according to this law to install it, this is the correct way to facilitate. When a large pipe to be bent, it must be within bending range. Use plastic composite pipe as hot water safety pipeline, we adopt the rubber seal, so as to avoid leakage phenomenon occur during use. During the installation, it must be in accordance with the design drawings for processing, according to the parameters of the above construction. Be sure to check whether it is high-quality fittings, installation is a very important part, playing a very important role for later use.

Plastic composite pipe is based on the seamless steel pipe and welded steel pipe, inner wall painting with high adhesion, corrosion, hygienic food grade polyethylene powder coating or epoxy painting, and is anti-corrosion, corrosion resistance, non-toxic, non-radiation green pipe, used in a variety of fluid transfer. LSAW steel pipe as base pipe shall conform to the requirements of GB / T3091-2008 for the base pipe; seamless steel pipe as base pipe should comply with the requirements of GB / T8163-2008 for the base pipe; and SSAW steel pipe shall comply with the requirements of SY / T5037-2000 for the base pipe.